Chief Manufacturing PWC-2000 Display Installation, Installation Instructions

PWC-2000 Installation Instructions

4.Carefully slide CPU between strap (E) and rear surface of side plates (See Figure 5). Ensure the following:

•Both loops of strap (E) are in front of the CPU; do not wrap strap (E) around back of CPU.

•CPU is positioned so that cooling vents are not obstructed.

4

5

Figure 5

5.Tighten strap (E) securely.

6.Re-install front plate by reversing the procedure in Step 2:

A.Tilt the top of the front plate towards you.

B.Lower the front plate onto the lower attach screws.

C.Tilt the top of the front plate away from you (towards the wall).

7.Using key (F), re-install the retained upper front plate attach screws and washers (See Figure 6).

NOTE: If desired, security screws (C) may be substituted for non-security screws at both upper and lower attach

	points.
	x2
	7
	x2
7	x2

Figure 6

DISPLAY INSTALLATION

WARNING: Exceeding the weight capacity can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the combined weight of all components attached to the PWC-2000 does not exceed

200lbs (90 kg).

1.Install interface providing 14" X 14" (356mm x 356mm) mounting button pattern to display. See instructions supplied with interface.

2.Rotate Q-Latch to the OPEN position (See Figure 7).

2

Figure 7

WARNING: Display is very heavy! Ensure display can be safely lifted and maneuvered as required to install to mount. Failure to take adequate precautions can result in serious personal injury or damage to equipment!

3.Lift and maneuver display so that all four mounting buttons on interface fit into button openings on front plate. Lower display firmly into place. Ensure each button has fully seated in its button opening (See Figure 8).

NOTE: Display not shown for clarity.

3

Figure 8

8