Child Craft CCH00701:09/00 manual Main Diagram, Crib Spring

CCH00701:09/00	3
MAIN DIAGRAM 6
TIGHTEN SCREW A MANUALLY, DO NOT USE ANY TYPE OF POWER SCREWDRIVER.
O
A	N
	K

A

K

P / Q

Top rail

Plastic pouch

D

B

						J
						F
						G
						I
Locate	the 4 Casters H, insert each	into a			Foot latch	H
lower	corner post of Headboard N/Footboard
O. Refer to Main Diagram 6. (Caster H					P / Q
design may possibly vary according to your
particular crib model.)					Bottom rail
CAUTION: If crib is placed on exception-					CLOSE UP VIEW
ally thick carpet, take care when crib is
rolled as Casters H could catch on thick
carpet pile and possibly cause breakage					K
or damage to lower corner posts of crib.				Hook end
			CRIB SPRING	down	D
				R:
					R
	H		Be sure the smooth side of wire is			Post
			placed up as illustrated. Also,style
			of Crib Spring R may differ with		B	Corner
			your model of crib.
Permanent Storage of Assembly Instructions:		After	completing the assembly		J	O
						/
process you are advised to read and be aware		of all	WARNINGS, CAUTIONS,			N

CLEANING, STORAGE, USE, and MAINTENANCE notices contained in this set of assembly directions and printed on the plastic pouch located on the underneath side of crib spring. You will then place this complete set of assembly directions into the plastic pouch for future referral. We caution you not to place excess hardware in the plastic pouch as it could present danger to a small child if retrieved.

Place a purchased mattress on Crib Spring R and crib is ready for use.

TO RAISE & LOWER CRIB DROPSIDE: To lower lift the dropside slightly, push the foot latch toward the inside of crib which will release the dropside to the lowest or "DOWN" position. To raise the dropside, lift up on the dropside, rail will then lock into the "UP" position.