Christie Digital Systems 103-002001 SETTING

This function turns Projection Lamp off when this projector detects

signal interruption and is not used for a certain period in order to

reduce power consumption and maintain the Lamp-life. (This

projector is shipped with this function ON.)

Power Management function operates to turn Projection Lamp off

when the input signal is interrupted and any button is not pressed

over 5 minutes. This function operates as follows;

1. When any input signal is interrupted, “No signal” and the

counting down display appears (for 5 minutes).

2. After counting down for 5 minutes, Projection Lamp and

READY Indicator are turned off. (Cooling Fans keep running.)

3. READY Indicator starts to flash after cooling down Projection

Lamp about for 90 seconds (Power Management mode).

In this Power Management mode, Projection Lamp is

automatically turned on when the input signal is connected or

projector is operated with any button on Top Control or on

Remote Control Unit again.

Power management

This function is used to reset Lamp Replace Counter. When

replacing Projection Lamp, reset Lamp Replace Counter by using

this function. Refer to page 38 for operation.

Lamp counter reset

Remote control

This projector has eight different remote control codes; the factory-

set normal code (Code 1) and the other seven codes (Code 2 to

Code 8). This switching function prevents remote control operation

mixture (jam) when operating several projectors or video equipment

together.

For example operating projector in “Code 7,” both projector and

Remote Control Unit must be switched to “Code 7.”

To change the code of Projector;

To change the Remote control code of the projector used in ON-

SCREEN MENU is selectable from Code 1 to Code 8.

To change the code of the Remote Control Unit;

To change the remote control code of the Remote Control Unit, set

the DIP switches 1-3 inside the battery compartment box of the

Remote Control Unit. (Refer to P14.)

On start

When this function is “On,” projector is automatically turned on just

by connecting AC Power cord to a wall outlet.

Note ; B e sure to turn projector off properly (refer to the section

“TURNING OFF PROJECTOR” on P19). If projector is turned

off in the wrong steps, On Start function does not operate

properly.

Time left until Lamp off.

Press SELECT button at this icon to

display other items.

SETTING

Lamp mode

When selecting the ""

(Eco), the projector reduce the brightness

and set into the low power consumption mode.

When pressing SELECT button at

Remote control, Remote control

code Menu appears.

Move the pointer to the item and

then press POINT LEFT/RIGHT

button(s).

Press SELECT button at this icon to

display previous items.

Code 1

Remote control