KW UNIT CONVERSION INSTRUCTIONS, KW Fixed Style Heater

13.5 kW UNIT CONVERSION INSTRUCTIONS

11-1/2"

23-5/8"

55-5/8"

13.5 kW Fixed Style Heater

INSTRUCTIONS FOR CONVERTING

A FIXED STYLE INTO A PORTABLE STYLE

(Installation of Cart making it a Portable Heater Voids UL Listing)

1.The kit (168-053169-057) that converts a 13.5 kW fixed style radiant heater into a protable includes the following parts. Verify that all parts are included, if not, contact the Chromalox Service Department at 1-800-368-2493.

(1)Lower Leg	(7)	Grille (2 Req’d)
(2)Axle	(8)	Baffle
(3)Wheel (2 Req’d)	(9)	1/4-20 x 1/2” long bolt (4 Req’d)
(4)Cap (2 Req’d)	(10)	1/2-20 Square nut (4 Req’d)
(5)Upper Handle	(11) Pop Rivet (6 Req’d)
(6)Grip (2 Req’d)	(12) No. 10 Sheet Metal Screw (6 Req’d)

2.	Using hammer tap cap (4) onto one end of axle (2). Slide one wheel (3)
	onto axle. Slide end of axle through both holes of lower leg (1). Slide
	remaining wheel onto portion of axle protruding through lower leg. Tap
	cap on axle.
3.	Remove Lower Bracket by removing nuts and washers.
4.	Slide the two 3/8” bolts in the outer extrusions to the 7-3/32” dimension
	and the one 3/8” bolt in the center extrusion to the 11-17/32” dimension.
5.	Place lower leg assy made in step 2 onto the three bolts. Secure in place
	with washers and nuts removed in step 3.
6.	Remove upper bracket by removing nuts and washers.
7.	Place upper handle (5) onto three bolts. secure in place with washers and
	nuts removed in step 6.
8.	Slide grips (6) onto ends of upper handle.
9.	Stand heater vertically. If heater does not sit evenly, loosen nuts that
	secure lower leg assy and adjust accordingly.
10. Rotate heater back until handle (5) is on floor.
11. Install baffle (8) using pop rivets, if pop rivet gun is not available use the
	NO. 10 sheet metal screws.