Cisco Systems 0L-11350-01 Configuring Multiple VLAN and Rate Limiting for Point-to-Multipoint Bridging

5-39
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-11350-01
Chapter5 Administering the Access PointWireless Device Access
Configuring Multiple VLAN and Rate Limiting for Point-to-Multipoint Bridging
Verifying the Migration
Use the show controllers command to confirm the migration as shown in this typical example:
ap#show controllers dot11Radio 1
!
interface Dot11Radio1
Radio AIR-AP1242A, Base Address 0013.5f0e.d1e0, BBlock version
0.00, Software version 5.95.7
Serial number: ALP0916W015
Number of supported simultaneous BSSID on Dot11Radio1: 8
Carrier Set: Japan (UNI1) (JP )
Uniform Spreading Required: No
Current Frequency: 0 MHz Channel 0
Allowed Frequencies: 5180(36) 5200(40) 5220(44) 5240(48)
Listen Frequencies: 5170(34) 5190(38) 5210(42) 5230(46) 5180(36)
5200(40) 5220(44) 5240(48) 5260(52) 5280(56) 5300(60) 5320(64)
5500(100) 5520(104) 5540(108) 5560(112) 5580(116) 5600(120)
5620(124) 5640(128) 5660(132) 5680(136) 5700(140) 5745(149)
5765(153) 5785(157) 5805(161) 5825(165)
Beacon Flags: 0; Beacons are disabled; Probes are disabled High Density mode disabled
Local Rx sensitivity (Config -127, Max -57, Min -17, Active 0) dBm
CCA Sensitivity -64 dBm
Cell Rx sensitivity -80 dBm, CCA Sensitivity -60 dBm, Tx Power 127 dBm
Current Power: 17 dBm
Allowed Power Levels: -1 2 5 8 11 14 15 17
Allowed Client Power Levels: 2 5 8 11 14 15 17
Current Rates: basic-6.0 9.0 basic-12.0 18.0 basic-24.0 36.0 48.0 54.0
Active Rates:
Allowed Rates: 6.0 9.0 12.0 18.0 24.0 36.0 48.0 54.0
Best Range Rates: basic-6.0 9.0 12.0 18.0 24.0 36.0 48.0 54.0
Best Throughput Rates: basic-6.0 basic-9.0 basic-12.0 basic-
18.0 basic-24.0 basic-36.0 basic-48.0 basic-54.0
Note The country code is updated from JP to JU after migration. Radios not migrated are still shown as
country code JP.
Configuring Multiple VLAN and Rate Limiting for
Point-to-Multipoint Bridging
This feature modifies the way point-to-multipoint bridging can be configured to operate on multiple
VLANs with the ability to control traffic rates on each VLAN. The feature is available on 32 Mb access
points configured as bridges (1240 series) and the 1300 series access point/bridge. The feature is not
available on 16 Mb access points (1100, 1200, and 350 series)
Note Rate limiting policy can only be applied to ingress ports of Fast Ethernet ingress ports on non-root
bridges.