Cisco Systems 0L-11350-01 Enabling the Radio Interface, Configuring the Role in Radio Network

6-2
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-11350-01
Chapter6 Configuring Radio Settings
Enabling the Radio Interface
Enabling the Radio Interface
The wireless device radios are disabled by default.
Note In Cisco IOS Release 12.3(8)JA there is no default SSID. You must create a Radio Service Set Identifier
(SSID) before you can enable the radio interface.
Beginning in privileged EXEC mode, follow these steps to enable the access point radio:
Use the shutdown command to disable the radio port.
Configuring the Role in Radio Network
Table 6 -1 shows the role in the radio network for each device.
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 dot11 ssid ssid Enter the SSID. The SSID can consist of up to 32 alphanumeric
characters. SSIDs are case sensitive.
Step3 interface dot11radio { 0 | 1slot/port
}
Enter interface configuration mode for the radio interface. The
2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1.
Step4 ssid ssid Assign the ssid you created in Step 2 to the appropriate radio
interface.
Step5 no shutdown Enable the radio port.
Step6 end Return to privileged EXEC mode.
Step7 copy running-config startup-config (Optional) Save your entries in the configuration file.
Table6-1 Device Role in Radio Network Configuration
Role in Radio Network AP1200 AP1100 AP1130 AP1240
1300AP/
BR
Access point X X X X X
Access point (fallback to radio
shutdown)
XXXXX
Access point (fallback to repeater) X X X X X
Repeater X X X X X
Root bridge X – – X X
Non-root bridge X – – X X
Root bridge with wireless clients X – – X X
Non-root bridge with wireless clients X – – X X
Workgroup bridge X X X X X