Cisco Systems 1417 quick start Verify Your Installation, For More Information

Verify Your Installation.

After the router is powered up, the following LEDs confirm that you have correctly installed

your router.

LED	Location	What to Look for
PWR	Front	On when power is being supplied to the router.
OK	Front	• One blink per second when the router is in ROM monitor
		mode.
		• Several blinks per second when the router is running the boot
		image in ROM monitor.
		• On steady when the Cisco IOS software is loaded and
		functional.
LNK	Rear	On when the router is correctly connected to the local Ethernet
		network through the ETHERNET port.
WAN CARRIER	Front	On when the router has synchronized with the DSL access
		multiplexer (DSLAM) at the service provider office.
ETHERNET ACT	Front	Blinking when there is network traffic on the Ethernet LAN.
OK	Rear	On when the Flash PC card is correctly installed in the router. If
		this LED is off, refer to the installation and configuration guide
		that came with your router for instructions on how to reinstall the
		Flash PC card.

For More Information

For more information about installing or configuring your Cisco 1417 router, refer to the following sources:

•Cisco 1400 Series Router Installation and Configuration Guide (in the accessory kit).

•The Cisco Connection Online card in the accessory kit, which lists telephone numbers, e-mail addresses, and URLs for getting information directly from Cisco Systems.

7