Manuals / Cisco Systems / Computer Equipment / Computer Accessories

Cisco Systems 2600I, 2602I The following standards were applied, EMC-EN 301.489-1 v1.8.1 EN

Models: 2602I 2600I AIRCAP2602IAK910 AIRCAP2602EAK9 AIRCAP2602IAK9 AIRCAP2602ICK9 AIRSAP2602EAK9 AIRSAP2602IAK9 2600

1 38

Download 38 pages 43.83 Kb

Page 27

Image 27

The following standards were applied:

EMC—EN 301.489-1 v1.8.1; EN 301.489-17 v2.1.1

Health & Safety—EN60950-1: 2005; EN 50385: 2002

Radio—EN 300 328 v 1.7.1; EN 301.893 v 1.5.1

The conformity assessment procedure referred to in Article 10.4 and Annex III of Directive 1999/5/EC has been followed.

Page 27

Image 27

Cisco Systems 2600 The following standards were applied, EMC-EN 301.489-1 v1.8.1 EN, Health & Safety-EN60950-1 2005 EN

Contents

GETTING STARTED GUIDE Cisco Aironet 2600 Series Access Points1 About this Guide 2 Introduction to the Access PointSAVE THESE INSTRUCTIONS 3 Safety InstructionsIMPORTANT SAFETY INSTRUCTIONS translated safety warnings that accompanied this device. Statement20A. Statement 5 Configurations 4 UnpackingExternal Antennas Internal Antennas Regulatory DomainsCountries Supported Antenna connector B 6 Access Point Ports and ConnectorsAntenna connector A Antenna connector C272377 LED indicatorFigure 2 Access Point LED Indicator top Figure 3 Access Point Ports and Connections bottomThe Controller Discovery Process 7 Configuring the Access PointPage Installation Summary Preparing the Access PointPerforming a Pre-Installation Configuration Pre-Installation Configuration SetupController Layer 3 devices Cisco Aironet access points 2811, 2821, and 2851 integrated services routers Step 2 Apply power to the access pointWS-C3550, WS-C3560, and WS-C3750 switches C1880 switch 2600, 2610, 2611, 2621, 2650, and 2651 multiservice platformsc. If the access point shuts down, check the power source 9 Deploying the Access Point on the Wireless Network 8 Mounting the Access PointChecking the Access Point LED 10 TroubleshootingGuidelines for Using Cisco Aironet Lightweight Access Points Using DHCP OptionStatus LED LED Status Indications continued Troubleshooting the Access Point Join ProcessPage 11 Declarations of Conformity and Regulatory Information Models VCCI Statement for Japan 03-6434-6500 Guidelines for Operating Cisco Aironet Access Points in JapanJapanese Translation English TranslationEnglish Translation Statement 371-Power Cable and AC AdapterIndustry Canada Canadian Compliance StatementModels European Community, Switzerland, Norway, Iceland, and LiechtensteinPage Radio-EN 300 328 v 1.7.1 EN Health & Safety-EN60950-1 2005 ENThe following standards were applied EMC-EN 301.489-1 v1.8.1 ENGeneric Discussion on RF Exposure Declaration of Conformity for RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Chinese Translation Administrative Rules for Cisco Aironet Access Points in TaiwanAdministrative Rules for Low-power Radio-Frequency Devices Article English TranslationChinese Translation English Translation Operation of Cisco Aironet Access Points in BrazilAccess Point Models Regulatory InformationFigure 6 Brazil Regulatory Information Declaration of Conformity StatementsPortuguese Translation English Translation12 Configuring DHCP Option 43 and DHCP Option Cisco AP c2600-ServiceProviderCisco AP c2600 Category 13 Access Point SpecificationsType + Length + Value Specificationrefer to Channels and Maximum Power Settings for Cisco Aironet 14 Obtaining Documentation and Submitting a Service Request2012 Cisco Systems, Inc. All rights reserved 78-20842-01