3-13
Catalyst 2960 Switch SoftwareConfiguration Guide
78-16881-01
Chapter3 Assigning the Switch IP Address and Default Gateway
Modifying the Startup Configuration
To return to the default setting, use the no boot config-file global configuration command.
Booting Manually
By default, the switch automatically boots; however, you can configure it to manually boot.
Beginning in privileged EXEC mode, follow these steps to configure the switch to manually boot during
the next boot cycle:
To disable manual booting, use the no boot manual global configuration command.
Booting a Specific Software Image
By default, the switch attempts to automatically boot the system using information in the BOOT
environment variable. If this variable is not set, the switch attempts to load and execute the first
executable image it can by performing a recursive, depth-first search throughout the flash file system. In
a depth-first search of a directory, each encountered subdirectory is completely searched before
continuing the search in the original directory. However, you can specify a specific image to boot.
Beginning in privileged EXEC mode, follow these steps to configure the switch to boot a specific image
during the next boot cycle:
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 boot manual Enable the switch to manually boot during the next bo ot cycle.
Step3 end Return to privileged EXEC mode.
Step4 show boot Verify your entries.
The boot manual global command changes the setting of the
MANUAL_BOOT environment variable.
The next time you reboot the system, the switch is in boot loader
mode, shown by the switch: prompt. To boot the system, use the
boot filesystem:/file-url boot loader command.
For filesystem:, use flash: for the system board flash device.
For file-url, specify the path (directory) and the name of the
bootable image.
Filenames and directory names are case sensitive.
Step5 copy running-config startup-config (Optional) Save your entries in the configuration file.