Cisco Systems 3560-X, 3750-X - page 1055

42-55
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 42 Configuring IP Unicast Routing Configuring BGP
path, community, and network numbers. Autonomous system path matching requires the match as-path
access-list route-map command, community based matching requires the match community-list
route-map command, and network-based matching requires the ip access-list global configuration
command.
Beginning in privileged EXEC mode, follow these steps to apply a per-neighbor route map:
Use the no neighbor distribute-list command to remove the access list from the neighbor. Use the no
neighbor route-map map-tag router configuration command to remove the route map from the
neighbor.
Another method of filtering is to specify an access list filter on both incoming and outbound updates,
based on the BGP autonomous system paths. Each filter is an access list based on regular expressions.
(See the “Regular Expressions” appendix in the Cisco IOS Dial Technologies Command Reference,
Release 12.2 for more information on forming regular expressions.) To use this method, define an
autonomous system path access list, and apply it to updates to and from particular neighbors.
Beginning in privileged EXEC mode, follow these steps to configure BGP path filtering:
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 router bgp autonomous-system Enable a BGP routing process, assign it an AS number, and enter
router configuration mode.
Step 3 neighbor {ip-address | peer-group name}
distribute-list {access-list-number | name}
{in | out}
(Optional) Filter BGP routing updates to or from neighbors as
specified in an access list.
Note You can also use the neighbor prefix-list router
configuration command to filter updates, but you cannot use
both commands to configure the same BGP peer.
Step 4 neighbor {ip-address | peer-group name}
route-map map-tag {in | out}
(Optional) Apply a route map to filter an incoming or outgoing
route.
Step 5 end Return to privileged EXEC mode.
Step 6 show ip bgp neighbors Verify the configuration.
Step 7 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 ip as-path access-list access-list-number
{permit | deny} as-regular-expressions Define a BGP-related access list.
Step 3 router bgp autonomous-system Enter BGP router configuration mode.
Step 4 neighbor {ip-address | peer-group name}
filter-list {access-list-number | name} {in |
out | weight weight}
Establish a BGP filter based on an access list.
Step 5 end Return to privileged EXEC mode.
Step 6 show ip bgp neighbors [paths
regular-expression]
Verify the configuration.
Step 7 copy running-config startup-config (Optional) Save your entries in the configuration file.