Cisco Systems 3560-X, 3750-X Configuring and Associating VLANs in a Private VLAN

18-9
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 18 Configuring Private VLANs Configuring Private VLANs
– Link Aggregation Control Protocol (LACP)
– Multicast VLAN Registration (MVR)
– voice VLAN
– Web Cache Communication Protocol (WCCP)
• You can configure IEEE 802.1x port-based authentication on a private-VLAN port, but do not
configure 802.1x with port security, voice VLAN, or per-user ACL on private-VLAN ports.
• A private-VLAN host or promiscuous port cannot be a SPAN destination port. If you configure a
SPAN destination port as a private-VLAN port, the port becomes inactive.
• If you configure a static MAC address on a promiscuous port in the primary VLAN, you must add
the same static address to all associated secondary VLANs. If you configure a static MAC address
on a host port in a secondary VLAN, you must add the same static MAC address to the associated
primary VLAN. When you delete a static MAC address from a private-VLAN port, you must remove
all instances of the configured MAC address from the private VLAN.
Note Dynamic MAC addresses learned in one VLAN of a private VLAN are replicated in the
associated VLANs. For example, a MAC address learned in a secondary VLAN is replicated
in the primary VLAN. When the original dynamic MAC address is deleted or aged out, the
replicated addresses are removed from the MAC address table.
• Configure Layer 3 VLAN interfaces (SVIs) only for primary VLANs.
Configuring and Associating VLANs in a Private VLAN
Beginning in privileged EXEC mode, follow these steps to configure a private VLAN:
Note The private-vlan commands do not take effect until you exit VLAN configuration mode.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 vtp mode transparent Set VTP mode to transparent (disable VTP).
Step 3 vlan vlan-id Enter VLAN configuration mode and designate or create a VLAN that
will be the primary VLAN. The VLAN ID range is 2 to 1001 and 1006
to 4094.
Step 4 private-vlan primary Designate the VLAN as the primary VLAN.
Step 5 exit Return to global configuration mode.
Step 6 vlan vlan-id (Optional) Enter VLAN configuration mode and designate or create a
VLAN that will be an isolated VLAN. The VLAN ID range is 2 to 1001
and 1006 to 4094.
Step 7 private-vlan isolated Designate the VLAN as an isolated VLAN.
Step 8 exit Return to global configuration mode.