Cisco Systems Common Solaris Installation Steps, zcat CSCOar-4.2.1-sol9-K9.tar.gz tar xvf

Chapter 2 Installing Cisco Access Registrar 4.2

Installing Cisco Access Registrar 4.2 Software on Solaris

Step 3 Use the following command line to uncompress the tarfile and extract the installation package files.

zcat CSCOar-4.2.1-sol9-K9.tar.gz tar xvf -

Note These instructions are for the Solaris 9 package. There is no difference in download or installation procedures for Solaris 9 or Solaris 10 other than the package name.

Step 4 Enter the following command to begin the installation:

pkgadd -d /tmp CSCOar

where /tmp is the temporary directory where you stored and uncompressed the installation files.

Step 5 Proceed to Common Solaris Installation Steps.

Common Solaris Installation Steps

This section describes the installation process immediately after you have issued the pkgadd command installing from CD-ROM or from downloaded software.

Processing package instance <CSCOar> from </tmp>

Cisco Access Registrar 4.2.1 [SunOS-5.9, official] (sparc) 4.2.1

Copyright (C) 1998-2008 by Cisco Systems, Inc.

This program contains proprietary and confidential information.

All rights reserved except as may be permitted by prior written consent.

This package contains the Access Registrar Server and the Access Registrar Configuration Utility. You can choose to perform either a Full installation or just install the Configuration Utility.

What type of installation: Full, Config only [Full] [?,q]

Step 6 For a full install, press Enter.

Where do you want to install <CSCOar>? [/opt/CSCOar] [?,q]

Step 7 Press Enter to accept the default location of /opt/CSCOar, or enter a different directory to be used as the base installation directory.

Access Registrar requires FLEXlm license file to operate. A list of space delimited license files or directories can be supplied as input; license files must have the extension ".lic".

Where are the FLEXlm license files located? [] [?,q]

Step 8 Enter the directory where you have stored the CAR 4.2 license file.

Access Registrar provides a Web GUI. It requires J2RE version 1.4.* to be installed on the server.

If you already have a compatible version J2RE installed, please enter the directory where it is installed. If you do not, the compatible J2RE version can be downloaded from:

Installing and Configuring Cisco Access Registrar, 4.2

OL-17221-02 2-3