6
Cisco Router and Security Device Manager (SDM) User Guide for the Cisco 7200 VXR and Cisco 7301 Routers
OL-5131-07
Installing SDM (Optional)
Router(config-line)# exit
Router(config)#
Step 4 (Optional) Enable local logging to support the log monitoring function. Enter the following command in
global configuration mode:
Router(config)# logging buffered 51200 warning
Step 5 Enter the end command to leave configuration mode:
Router(config)# end
Router#
Installing SDM (Optional)SDM comes preinstalled on the Flash Disk or CompactFlash Disk as part of your Cisco 7204VXR,
Cisco 7206VXR, or Cisco 7301 router. You can also download/upgrade SDM free of charge from the
Software Center on Cisco.com at: http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm.
For instructions on installing SDM, see Downloading and Installing Cisco Router and Security Device
Manager at
http://www.cisco.com/en/US/products/sw/secursw/ps5318/tsd_products_support_series_home.html
Launching SDM To start SDM on your router using a PC browser to access SDM, follow these steps:
Step 1 Open a web browser on a PC, and enter the following URL:
https://router_interface_IP_address
where router_interface_IP_address is the router IP address.
Note https://... specifies that the Secure Sockets Layer (SSL) protocol be used for a secure connection.
http://... can be used if SSL is not available.
If you do not enter https:// and you are using Windows IE, you will receive a message, warning you that
you are not in secure mode. Click OK to configure in secure mode, or click Cancel to continue using
http (see Figure 1).