Cisco Systems 7971G-GE Adding Phones with Cisco, Unified Communications, On page 2-16for details

Chapter 7 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone

Status Menu

Table 7-2		Status Messages on the Cisco Unified IP Phone 7970 Series
	Message			Description	Possible Explanation and Action
	BootP server used			The phone obtained its IP address from	None. This message is informational
				a BootP server rather than a DHCP	only.
				server.
	CFG file not found			The name-based and default	The configuration file for a phone is
				configuration file was not found on the	created when the phone is added to the
				TFTP Server.	Cisco Unified Communications
					Manager database. If the phone has not
					been added to the
					Cisco Unified Communications
					Manager database, the TFTP server
					generates a CFG File Not Found
					response.
					• Phone is not registered with
					Cisco Unified Communications
					Manager.
					You must manually add the phone
					to Cisco Unified Communications
					Manager if you are not allowing
					phones to auto-register. See the
					“Adding Phones with Cisco
					Unified Communications
					Manager Administration” section
					on page 2-16for details.
					• If you are using DHCP, verify that
					the DHCP server is pointing to the
					correct TFTP server.
					• If you are using static IP
					addresses, check configuration of
					the TFTP server. See the “Network
					Configuration Menu” section on
					page 4-7for details on assigning a
					TFTP server.
	CFG TFTP Size			The configuration file is too large for	Power cycle the phone.
	Error			file system on the phone.
			Cisco Unified IP Phone 7970G/7971G-GE for Cisco Unified Communications Manager 6.0
	OL-12232-01					7-5