6Connect the Cisco 800 Series Router to a Hub
Follow these steps to connect the Cisco 805 router to a hub:
Figure 2 Connecting a Cisco 805 Router to a Hub
| HUB |
LINK | NO HUB |
ETHERNET | |
| CONSOLE |
10 | BASE T |
| |
Cisco | 805 |
|
SERIAL |
Cisco 805 Router
SPEED | LED | |
100BaseTX | ||
SOLID | ||
10BaseT | ||
BLINK |
1X |
|
|
2X | 10/100 |
|
| 3X | |
|
| 4X |
1 | 2 | 3 | 4 |
5 | 6 | 7 | 8 |
|
| ||
|
|
| 5X |
|
|
| 6X |
|
|
| 7X |
|
|
| 8X |
MDI |
Cisco 1528 Micro Hub 10/100
Step 1 Connect the yellow Ethernet cable from the yellow Ethernet port on the back panel of the router to the Ethernet port on the hub.
Step 2 Verify that the HUB/NO HUB switch on the left side of the back panel has been set to the HUB position (in). If the button is out, press it to set it to the in position.
7Connect the Cisco 805 Router to a Serial Drive
The following table describes the devices most commonly connected to the router serial port and how the serial line is used.
Serial Device | WAN Options | WAN Encapsulation (Framing) | Network Type |
|
|
|
|
Asynchronous | Asynchronous | Remote office to | |
modem |
| corporate office | |
|
|
| Small office to Internet |
|
|
| service provider (ISP) |
|
|
|
|
Channel service | Synchronous | Synchronous leased line: | Remote office to |
unit/data service | leased line | corporate office | |
unit (CSU/DSU) | Frame Relay | (HDLC) or PPP | Small office to ISP |
|
| ||
| X.25 | Frame Relay |
|
|
|
| |
|
| X.25 |
|
|
|
|
|
5
