Chapter 19 Managing the AIP SSM and CSC SSM
Transferring an Image onto an SSM
To transfer an image onto an intelligent SSM, perform the following steps:
Step 1 Create or modify a recovery configuration for the SSM. To do so, perform the following steps:
a.Determine if there is a recovery configuration for the SSM. To do so, use the show module command with the recover keyword, as follows.
hostname# show module slot recover
where slot is the slot number occupied by the SSM.
If the recover keyword is not valid, a recovery configuration does not exist. The recover keyword of the show module command is available only when a recovery configuration exists for the SSM.
Note When the adaptive security appliance operates in multiple context mode, the configure keyword is available only in the system context.
If there is a recovery configuration for the SSM, the adaptive security appliance displays it. Examine the recovery configuration closely to ensure that it is correct, especially the Image URL field. The following example show a recovery configuration for an SSM in slot 1.
hostname# show module 1 recover Module 1 recover parameters. . .
Boot Recovery Image: Yes
Image URL: | |||
Port | IP | Address: | 10.1.2.10 |
Port | Mask : | 255.255.255.0 | |
Gateway | IP Address: | 10.1.2.254 |
b.If you need to create or modify the recovery configuration, use the
hostname#
where slot is the slot number occupied by the SSM.
Complete the prompts as applicable. If you are modifying a configuration, you can keep the previously configured value by pressing Enter. The following example shows the prompts. For more information about them, see the entry for the
Image URL [tftp://0.0.0.0/]:
Port IP Address [0.0.0.0]:
VLAN ID [0]:
Gateway IP Address [0.0.0.0]:
Note Be sure the TFTP server you specify can transfer files up to 60 MB in size. Also, be sure the TFTP server can connect to the management port IP address that you specify for the SSM.
After you complete the prompts, the adaptive security appliance is ready to transfer to the SSM the image that it finds at the URL you specified.
Step 2 Transfer the image from the TFTP server to the SSM and restart the SSM. To do so, use the
hostname#
where slot is the slot number occupied by the SSM.
|
| Cisco Security Appliance Command Line Configuration Guide |
|
| |
|
|
| |||
|
|
|
|
| |
|
|
|
|