3-30
Cisco UCS C24 Server Installation and Service Guide
OL-26647-01
Chapter 3 Maintaining the Server
Installing or Replacing Server Components
Replacing the Motherboard RTC Battery
Warning
There is danger of explosion if the battery is replaced incorrectly. Replace the battery only with the
same or equivalent type recommended by the manufacturer. Dispose of used batteries according to
the manufacturer’s instructions.
[Statement 1015]
The real-time clock (RTC) battery retains system settings when the server is disconnected from power.
The RTC battery is on the motherboard under the fan tray.
The battery type is Panasonic CR2032 or equivalent.
To replace or install the motherboard CMOS battery, follow these steps:
Step 1 Remove the RTC battery (see Figure 3-18):
a. Power off the server as described in the “Shutting Down and Powering Off the Server” section on
page 3-6.
b. Slide the server out the front of the rack far enough so that you can remove the top cover. Y ou might
have to detach cables from the rear panel to provide clearance.
Caution If you cannot safely view and access the component, remove the server from the rack.
c. Remove the top cover as described in “Removing and Replacing the Server Top Cover” section on
page 3-7.
d. Locate the RTC battery on the motherboard between the PCIe risers (see Figure 3-18).
e. Use a small screwdriver or pointed object to push aside the metal clip that holds the battery in the
holder.
Note If you have difficulty reaching the battery because of cards in the PCIe risers, remove PCIe
riser 1 to provide access. See Replacing a PCIe Riser, page 3-32.
f. Lift the battery from the holder.
Step 2 Install an RTC battery:
a. Insert the battery into its holder positive-side-up and press down until it clicks in place.
Note The positive side of the battery marked “3V+” should face upward.
b. If you removed PCIe riser 1, replace it to its slot. See Replacing a PCIe Riser, page 3-32.
c. Replace the top cover.
d. Replace the server in the rack, replace cables, and power on the server by pressing the Power button.