77-3 Setting passwords

Passwords from the Control Panel

For more information on Administrator access privileges, see page 3-3. For information on controlling print jobs with the job management tools, see the Job Management Guide.

NOTE: The Operator password can be set and changed only from Fiery WebSetup, or Command WorkStation.

TO CHANGE THE FIERY PASSWORD

1.Scroll through the main Setup menu and choose Change Password.

2.Enter and confirm the password, as follows.

New Password

Use the and keys to select the characters and the ENTER key to advance to the next character position. When the last character has been entered (ENTER key pressed) password entry is complete. The password can be any combination of letters and numbers up to 19 characters.

Caution: If you decide to set an administrator password make sure you keep a careful note of it. If you lose or forget this password it cannot be recovered for you, and the internal hard disk drive containing the operating system and all settings will need to be replaced.

Verify New Password

Reenter the new password, exactly as you entered it initially. If you make a mistake, you are prompted to enter the password again. The new password is effective after you save changes and restart the Fiery.