11
To place the switch on a desk without using the mounting screws, simply attach the four rubber feet
on the bottom panel of the switch. To install the switch on top of a desk, under a desk, or on a wall,
use the mounting template and three mounting screws.
Follow these steps:
1. Position the screw template on the mounting surface with the two side-by-side slots forward. Peel
the adhesive strip off the bottom and attach the template.
2. Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2-inch (12.7 mm) hole in the three template
screw slot positions.
3. Insert the screws in the slots on the template and tighten until they touch the template. Remove
the template from the mounting surface.
4. Place the switch onto the mounting screws, and slide it forward until it locks in place.
1x 2x 3x 4x 5x 6x 7x 8x
Catalyst 2940
SERIES
1
SYST
STAT
DPLX
SPD
MODE
Number-8 Phillips pan-head screws
Mounting template