Cisco Systems CATALYST 2940

Step7 Connect a straight-through

Category 5 Ethernet cable (not

provided) to any 10/100 or

10/100/1000 Ethernet port on the

switch front panel and to the

Ethernet port on the PC.

Step8 Verify that the LEDs on both Ethernet ports are green.

Step9 Wait 30 seconds.

Step10 Launch a web browser on your PC.

Enter the IP address 10.0.0.1 in the

web browser, and press Enter.

Step11 The Express Setup page appears. If it does not appear, see the “In Case of Difficulty”

section on page 15 for help.

1x 2x 3x 4x 5x 6x 7x 8x

Catalyst 2940

SERIES

SYST

STAT

DPLX

SPD

MODE

DHCP-enabled PC

Contents

Main Catalyst 2940 Switch Getting Started Guide INCLUDING LICENSE AND WARRANTY 1 2 Equipment That You Supply to Run Express Setup Shipping Box Contents 3 Page Page Refreshing the PC IP Address 4 Using the Device Manager Downloading Cisco Network Assistant Command-Line Interface Other Management Options 5 Equipment That You Supply Before you Begin Installation Warning Statements Installing the Switch on a Desk or Wall Installing the Switch Using the Magnet Mount Connecting to the Switch Ports Connect to 10/100 Ports and the 10/100/1000 Port Connect to the 100BASE-FX Port Install and Connect to SFP Module Port SFP module port 6 Troubleshooting Express Setup Resetting the Switch Accessing Help Online For More Information 7 Cisco.com Ordering Documentation Documentation Feedback 8 Cisco Technical Support Website Submitting a Service Request Definitions of Service Request Severity Obtaining Additional Publications and Information 9 Page Cisco Website at www.cisco.com/go/offices