Cisco Systems Checking Power, Low Power Condition

22-21
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-29225-01
Chapter22 Troubleshooting
Checking Power
•Cisco Aironet Power Injector LR2—standard (included with the bridge)
– 48-VDC input power
– Uses the 48-VDC power module (included with the bridge)
•Cisco Aironet Power Injector LR2T—optional transportation version
– 12- to 40-VDC input power
– Uses 12 to 40 VDC from a vehicle battery
Checking Power
You can verify the availability of power to the access point/bridge by checking the power injector LED
(see Figure 22-10):
•Power LED
– Green color indicates input power is being supplied to the bridge.
– Red color indicates an overcurrent or overvoltage error condition—disconnect input power from
the power injector, check all coax cable connections for a possible short, wait approximately 1
minute, and reconnect input power to the power injector. If the LED turns red again, contact
technical support for assistance.
Note The power injector requires approximately 50 seconds to recover from an overcurrent or
overvoltage condition.
Off indicates input power is not available—verify that the power module is connected to the power
injector and that AC power is available or that 12- to 40-VDC input power is connected to the power
injector.
Low Power Condition
Access points can be powered from the 48-VDC power module or from an in-line power source. The
1040, 1130, 1140, 1240, 1250, and 1260 access points support the IEEE 802.3af power standard, Cisco
Pre-Standard PoE protocol , and Cisco Intelligent Power Management for in-line power sources.
For full operation, the 1040, 1130, 1140, 1240, 1250, and 1260 series access points require 12.95 W of
power. The power module and Cisco Aironet power injectors are capable of supplying the required
power for full operation, but some inline power sources are not capable of supplying 12.95 W. Also,
some high-power inline power sources, might not be able to provide 12.95 W of power to all ports at the
same time.
Note An 802.3af compliant switch (Cisco or non-Cisco) is capable of supplying sufficient power for full
operation.
On power on, the 1040, 1130, 1140, 1240, 1250, and 1260 series access points are placed into low power
mode (both radios are disabled), Cisco IOS software loads and runs, and power negotiation determines
if sufficient power is available. If there is sufficient power then the radios are turned on; otherwise, the