Chapter 3 Connecting the Cisco MDS 9216 Switch

Connecting to the MGMT 10/100 Ethernet Port

Send documentation comments to mdsfeedback-doc@cisco.com.

The default COM1 settings are as follows:

line Aux:

Speed: 9600 bauds

Databits: 8 bits per byte

Stopbits: 1 bit(s)

Parity: none

Modem In: Enable Modem Init-String -

default : ATE0Q1&D2&C1S0=1\015

Statistics: tx:17 rx:0 Register Bits:RTSDTR

Connecting to the MGMT 10/100 Ethernet Port

Caution To prevent an IP address conflict, do not connect the MGMT 10/100 Ethernet port to the network until the initial configuration is complete. For configuration instructions, refer to the Cisco MDS 9000 Family Configuration Guide.

The MGMT 10/100 Ethernet port (labeled MGMT 10/100) is autosensing and has an RJ-45 interface (Figure 3-3 on page 3-7). You can use this port to access and manage the switch by IP address, such as through Fabric Manager.

 

Cisco MDS 9216 Switch Hardware Installation Guide

3-6

78-16165-01

Page 6
Image 6
Cisco Systems MDS 9216 manual Connecting to the Mgmt 10/100 Ethernet Port, Default COM1 settings are as follows