EMC Environmental Conditions for Products Installed in the European Union
EMC Environmental Conditions for Products Installed in the European Union
This section applies to products to be installed in the European Union.
The equipment is intended to operate under the following environmental conditions with respect to EMC:
•A separate defined location under user’s control.
•Earthing and bonding shall meet the requirements of ETS 300 253 or CCITT K27.
•AC power distribution shall be one of the following types, where applicable:
In addition, if equipment is operated in a domestic environment, interference may occur.
EMC Class A Notices and Warnings
This section includes these EMC Class A warnings for the Cisco ME
•Statement
•Statement
•Statement
•Statement
•Statement
Class A Notice for FCC
Modifying the equipment without Cisco’s authorization may result in the equipment no longer complying with FCC requirements for Class A digital devices. In that event, your right to use the equipment may be limited by FCC regulations, and you may be required to correct any interference to radio or television communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case users will be required to correct the interference at their own expense.
Class A Notice for Canada
This Class A digital apparatus complies with Canadian
Cet appareil numérique de la classe A est conforme à la norme
Regulatory Compliance and Safety Information for the Cisco ME
50 |
| |
|
