Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Using Cisco Unified IP Phones with Different Protocols
Refer to Cisco Unified Communications Manager Administration Guide for detailed information about Cisco Unified Communications Manager configuration. Refer to Cisco Unified Communications Manager Bulk Administration Guide for detailed information about using the BAT.
Step 2 If you are not using DHCP in your network, configure the network parameters for the phone.
See the “Configuring Startup Network Settings” section on page
Step 3 Power cycle the phone.
Converting an In-Use Phone from SCCP to SIP
You can use the Bulk Administration Tool (BAT) to convert a phone that is in use in your network from SCCP to SIP. To access BAT from Cisco Unified Communications Manager Administration, choose Bulk Administration > Phones > Migrate Phones > SCCP to SIP. For detailed information, refer to Cisco Unified Communications Manager Bulk Administration Guide.
Converting an In-Use Phone from SIP to SCCP
To convert a phone that is in use in your network from SIP to SCCP, perform these steps. For more information, Cisco Unified Communications Manager Administration Guide.
Procedure
Step 1 In Cisco Unified Communications Manager Administration, delete the existing SIP phone from the Cisco Unified Communications Manager database.
Step 2 In Cisco Unified Communications Manager Administration, create the phone as an SCCP phone.
Step 3 Power cycle the phone.
Cisco Unified IP Phone
| ||
|
