Chapter 3 Setting Up the Cisco Unified IP Phone
Understanding the Cisco Unified IP Phone 7931G Components
Use the SW network port to connect the phone to the network. You must use a
Use the PC access port to connect a network device, such as a computer, to the phone. You must use a
Handset
The handset is designed especially for use with the Cisco Unified IP Phone 7931G. It includes a light strip that indicates incoming calls and voice messages waiting.
To connect a handset to the Cisco Unified IP Phone, plug the cable into the handset and the Handset port on the back of the phone.
Note The handset does not support wideband audio.
Speakerphone
By default, the speakerphone is enabled on the Cisco Unified IP Phone 7931G.
You can disable the speakerphone by using the Cisco Unified Communications Manager Administration. To do so, choose Device > Phone and locate the phone you want to modify. In the Phone Configuration window for the phone, check the Disable Speakerphone check box.
Headset
Although Cisco performs internal testing of
Cisco recommends the use of good quality external devices, for example, headsets that are screened against unwanted radio frequency (RF) and audio frequency (AF) signals. Depending on the quality of headsets and their proximity to other devices such as mobile phones and
Note The Cisco Unified IP Phone 7931G supports wideband headsets.
Note In some cases, hum may be reduced or eliminated by using a local power cube or power injector.
These environmental and hardware inconsistencies in the locations where Cisco Unified IP Phones are deployed means that there is not a single headset solution that is optimal for all environments.
Cisco recommends that customers test headsets in their intended environment to determine performance before making a purchasing decision and deploying en mass.
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 7.1 (SCCP and SIP)
|
| ||
|
|
