Chapter 2 Initial Switch Configuration
Using the Switch Setup Utility
Se n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a ck - d o c @ c i s c o . c o m
Step 18 Enter on (on is the default) to configure the switch port trunk mode.
Configure default switchport trunk mode (on/off/auto) [on]: on
Step 19 Enter deny (deny is the default) to configure a default zone policy configuration.
Configure default zone policy (permit/deny) [deny]: deny
This step denies traffic flow for all members of the default zone.
Step 20 Enter yes (no is the default) to enable a full zone set distribution (refer to the Cisco MDS 9000 Family CLI Quick Configuration Guide).
Enable full zoneset distribution (yes/no) [n]: yes
You see the new configuration. Review and edit the configuration that you have just entered.
Step 21 Enter no (no is the default) if you are satisfied with the configuration.
The following configuration will be applied:
switchname switch_name interface mgmt0
ip address mgmt_IP_address subnetmask mgmt0_ip_netmask no shutdown
ip
no ssh server enable
no system default switchport shutdown system default switchport trunk mode on no zone
Would you like to edit the configuration? (yes/no) [n]: no
Step 22 Enter yes (yes is the default) to use and save this configuration.
Use this configuration and save it? (yes/no) [y]: yes
Caution If you do not save the configuration at this point, your changes will not be updated the next time that the switch is rebooted. Type yes to save the new configuration to ensure that the kickstart and system images are also automatically configured.
Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide
| ||
|
