Configuring Modular Quality of Service Congestion Management on Cisco IOS XR Software
Information About Configuring QoS Congestion Management on Cisco IOS XR Software
Traffic Shaping
Traffic shaping allows you to control the traffic flow exiting an interface to match its transmission to the speed of the remote target interface and ensure that the traffic conforms to policies contracted for it. Traffic adhering to a particular profile can be shaped to meet downstream requirements, thereby eliminating bottlenecks in topologies with
To match the rate of transmission of data from the source to the target interface, you can limit the transfer of data to one of the following:
•A specific configured rate
•A derived rate based on the level of congestion
The rate of transfer depends on these three components that constitute the token bucket: burst size, mean rate, and time (measurement) interval. The mean rate is equal to the burst size divided by the interval.
When traffic shaping is enabled, the bit rate of the interface does not exceed the mean rate over any integral multiple of the interval. In other words, during every interval, a maximum of burst size can be sent. Within the interval, however, the bit rate may be faster than the mean rate at any given time.
When the exceed burst size (Be) equals 0, the interface sends no more than the burst size every interval, achieving an average rate no higher than the mean rate. However, when the Be size is greater than 0, the interface can send as many as the conform burst size (Bc) plus Be bits in a burst, if in a previous time period the maximum amount was not sent. Whenever less than the burst size is sent during an interval, the remaining number of bits, up to the Be size, can be used to send more than the burst size in a later interval.
Traffic Shaping Mechanism Regulates Traffic
When incoming packets arrive at an interface. The packets are classified using a classification technique, such as use of an access control list (ACL) or setting of the IP Precedence bits through the Modular QoS CLI (MQC). If the packet matches the specified classification, the traffic shaping mechanism continues. Otherwise, no further action is taken.
Cisco IOS XR Modular Quality of Service Configuration Guide
