Cisco Systems WIC-1DSU-T1-V2 manual Management, Regulatory Compliance, Standards

∙Self-test

–Self-test activated by user

∙Test patterns (BERT)

–1:2, 1:5, 1:8, 3:24, QRW, All 0s, All 1s, user-programmable 24-bit patterns

∙Network (T1) alarms

–Red alarm: Loss of network signal

–Blue alarm: Loss of network frame (AIS) from network

–Yellow alarm: Receive from network

∙Performance reports and error counters

–Cyclic redundancy check (CRC), bipolar violation (BPV), OOF [EXPAND?], errored seconds, burst errored seconds, severely errored seconds, Ft and Fs framing errors for SF framing, FPS [EXPAND?] framing errors for ESF framing, 24-hour history stored in 15-minute increments

∙LEDs

–CD (data carrier detect)

–LP (loopback)

–AL (alarm)

Management

∙Telnet/console

–Remote and local configuration, monitoring, and troubleshooting from Cisco IOS CLI

∙SNMP

–Router and DSU/CSU managed by single SNMP agent; router, DSU, and CSU appear as a single network entity to user

–Standard MIB (MIB II)

–Cisco integrated DSU/CSU MIB

–RFC 1406

∙SNMP traps

–Generated in response to alarms

Regulatory Compliance

∙FCC Part 15 Class B

∙TIA/EIA-IS-968

∙Industry Canada CS-03 Part II

∙JATE Digital

∙CAN/CSA-C22.2 No. 60950-00

∙UL 60950-2000

∙IEC/EN 60950

∙TS001

∙AS/NZS 3260

∙NEBS Type I/III

Standards

∙AT&T Pub 62411

∙ANSI T1.403

© 2005 Cisco Systems, Inc. All rights reserved.

Important notices, privacy statements, and trademarks of Cisco Systems, Inc. can be found on cisco.com.

Page 5 of 7