Cisco Systems WS-G5486, WS-G5487 Standards Compliance Specifications, Removing a GBIC with Clips

Standards Compliance Specifications

Removing a GBIC with Clips

If you are removing a GBIC that has clips, follow these steps:

Step 1 Disconnect the network fiber-optic cable from the GBIC SC-type connector.

Step 2 Release the GBIC from the slot by simultaneously squeezing the two plastic tabs (one on each side of the GBIC).

Step 3 Slide the GBIC out of the Gigabit Ethernet module slot. A flap drops down to protect the Gigabit Ethernet module connector.

Step 4 Place the GBIC in an antistatic bag.

Removing a GBIC with a Handle

If you are removing a GBIC with a handle, follow these steps:

Step 1 Disconnect the network fiber-optic cable from the GBIC SC-type connector.

Step 2 Rotate the handle up to release the GBIC from the slot.

Step 3 Grip the handle or the sides of the GBIC and slide the GBIC out of the slot. A flap drops down to protect the slot.

Step 4 Place the GBIC in an antistatic bag.

Standards Compliance Specifications

This section provides compliance information for the GBIC.

FCC Class A Compliance

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case users will be required to correct the interference at their own expense.

	Gigabit Interface Converter Installation Note
78-5399-03 Rev. A0		11