Cisco Systems WSC2960XR48TSI Understanding Abbreviated Commands, Understanding no and default Forms of Commands

2-4
Catalyst 2960 Switch SoftwareConfiguration Guide
78-16881-01
Chapter2 Us ing the Command-Line Interfac e
Understanding Abbreviated Commands
Understanding Abbreviated Commands
You need to enter only enough characters for the switch to recognize the com mand as unique.
This example shows how to enter the showconfiguration privileged EXEC command in an abbreviated
form:
Switch# show conf
Understanding no and default Forms of Commands
Almost every configuration command also has a no form. In general, use the no form to disable a feature
or function or reverse the action of a command. For example, the no shutdown interface configuration
command reverses the shutdown of an interface. Use the command without the keyword no to re-enable
a disabled feature or to enable a feature that is disabled by default.
Configuration commands can also have a default form. The default form of a command returns the
command setting to its default. Most commands are disabled by default, so the default form is the same
as the no form. However, some commands are enabled by default and have variables set to certain default
values. In these cases, the default command enables the command and sets variables to their default
values.
?List all commands available for a particular command mode.
For example:
Switch> ?
command ? List the associated keywords for a command.
For example:
Switch> show ?
command keyword ?List the associated arguments for a keyword.
For example:
Switch(config)# cdp holdtime ?
<10-255> Length of time (in sec) that receiver must keep this packet
Table2-2 Help Summary (continued)
Command Purpose