Set the partition to the width of the paper roll you are loading. The partition is set at the factory to the position shown below.
zFor
zFor
1.Turn off the power.
2.Press up on the cover open button to open the paper cover.3.Press in the position shown by the arrow and set the partition in a slot that matches the width of the paper roll you are using. However, to use an
4.Refer to “5.3 Manual Setting of Memory Switches” to change the paper width settings.
Partition
*1
*1*2
Notes:
*1:
*2:
CAUTION
Make sure the partition is not slanted when setting it for
— 23 —