CITIZEN QUARTZDIGI-ANA MARINEModel No. JG1❈❈❈ Caliber No. C350• INSTRUCTION MANUALCTZ-E6792
Thank you very much for purchasing a CITIZEN
QUARTZ WATCH. To ensure correct use, please
read these instructions carefully. Please ensure that
the Citizen international guarantee card is supplied
with watch on purchase, that you may claim the
guarantee service (subject to the terms of guarantee).
1. Features
This watch has an EL(electro-luminescence)
illumination that evenly illuminates the digital display
for easy viewing in dark locations.
2. Operating Instructions
3. Switching Modes (Functions)
In addition to the time/calendar mode, the watch has
four modes: Alarm 1, Alarm 2, Chronograph and
Timer. Each time button Mis pressed, the mode
display is switched in the following order:
[TIME] [ALM1] [ALM2] [CHR] [TMR].
Note: If the watch is left in the ALM1 or ALM2 mode
for 2 to 3 minutes, the display automatically
returns to TIME mode.
4. EL (Electro Luminescence) Illumination
While pressing button A, with the crown in any
position, the display is illuminated.
[EL]
ELpanel of this watch is a fluorescent panel which
illuminates when voltage is applied to it.
[Characteristics and replacement of the EL panel]
The electro luminescence panel has the following
properties.
• When the battery voltage drops, the brightness
(intensity) also drops.
• It is adversely affected by humidity.
If any water enters inside the watch by accident,
promptly request repair.
• The ELpanel has a finite life span.
The brightness (intensity) gradually drops in
proportion to the total number of hours of use (light
emission).
If the display appears dark or is hard to see when
the ELpanel comes on, ask either the store where
you purchased the product or your nearest CITIZEN
Service Centre to replace the ELpanel.
This repair will be done for a fee.
5. Setting the Time and Calendar
A. Digital setting
1) While in the time mode, press button
Cfor one second or more, seconds
will flash and switch to correcting state.
2) While seconds flash, press button Bto reset the
seconds to “00” after that seconds start again.
3) When in the seconds correcting state (second
flash), press button C, the flashing digit will
change in order of seconds-minutes-hours-month-
date-day-12/24 hour- (Analog time setting)
system. Select the digit to correct.
4) Correct the flashing digit by pressing button B.
(Press and hold down button Bquick advance to
flashing digit.)
When reading this instruction manual please
keep the watch diagram at left folded out and in
view. Symbols used in the sections on operating
instructions refer to the symbols indicated in this
diagram.