5) Press button Cor Mto complete setting.
Press button B, the Time and Calendar display will
switch alternately.
5) * Press button B, the 12 hour/24 hour will switch
alternately.
5) * If the time correct state (flashing digit) remains for
longer than 2 to 3 minutes, the watch will
automatically return to normal time display model
5) * Press button Mwhile in the time correct state,
can return the watch to normal display mode.
(Manual return)
5) * Due to the auto-calendar, no correcting at the end
of the month is required.
B. Analog time setting
This Analog time settings are electromagnetic
correction system.
1) While in the time correction mode, set the mode to
Analog time setting (A-SET display and all digital
digit flashing) by pressing button C.
2) Set the hour/minute hand to the desired time by
pressing button B.
* Press button B each time, hands will move one
minute increment.
2) * Press button B continuously, hands will move
quick advance.
[Alarm ON/OFF]
Switch the alarm ON/OFF by pressing button B.
[Alarm monitor]
In the alarm mode, while pressing button B, the alarm
monitor will sound.
6. Using the Alarm 1 [ALM1] or Alarm 2 [ALM2]
Operating the Alarm 1 and Alarm 2 are same, only
alarm sound different. When the alarm indicator is
ON, the alarm will sound for 20 seconds at the alarm
set time, once a day.
[Setting the alarm] 1) While in the alarm mode,
press button C, the hour will
start flashing and alarm will
indicate ON automatically.
2) While hour flashes, press
button Bto set the hours.
3) Press button C, the flashing
digit will change in this order:
hours ➝ minutes.
4) While minutes flash, press button Bto set the
minutes.
5) Press button C or M to finalize setting.
* Press and hold down button Bto quick advance
the flashing digit.
5) * Alarm 12 hours/24 hours is set in synchronized
with the time/calendar mode.
[Stop the alarm sound]
Press any button to stop the alarm sound.
7. Using Chronograph [CHR]
• The chronograph can measure up to 24 hours in
1/100 seconds.
• The chronograph display automatically returns to 00
and stops after 24 hours measurement.
[Chronograph timing display]
[Using the chronograph]
*1 Automatically switched after 10 seconds.
*2 When the same button Cis pressed again during
the display of a split time, the next split time is
displayed.
8. Using Timer [TMR]
• The timer can be set up to 99 minutes in 1 minute.
• The timer automatically switched to chronograph
measurement when the timer time is up.
• Awarning sound before the set time is up and sound
beep when the time is up.
[Setting timer]
• Press button C to advance
one minute at a time.
• Press button C continuously,
minutes will move quick
advance.
[Timer start/stop]
• Press button B to start the timer after the timer is set.
Astart beep sounds once at this time.
• Press button B at any time the timer is in motion to
stop the timer. Press button B again to restart the
timer.
• Press button C to reset the timer while the timer is
stopped.