Citizen MA9XXX Cancelling diving mode, Surface mode Measurement of reset time on surface

5)The water temperature displays after 1 min. then it measures and displays the water temperature every second. The water temperature range is –50C to 400C. When it is out of range, it displays [0C].

6)While pressing A button you can confirm normal time. When you release A button the watch returns to the depth display after 1.5 secs. Pressing C button activates the lamp for a maximum of 10 secs. The lamp switches off 1.5 secs after releasing C button.

One dive: In this watch, one dive starts from the time you dive deeper than 1m (4ft) to the time you return shallower than 1m (4ft) depth.

However when diving deeper than 1m (4ft) after being shallower than 1m (4ft) for less than 10 mins, the watch will record it as one continuous dive.

• An example of 1 dive: (valid diving)

•Display examples of valid and invalid diving for this watch

Cancelling diving mode

After Diving

1)If you stay shallower than 1m (4ft) (depth display “0.0m”) for more than 10 mins, the diving mode will be cancelled automatically. After cancellation, the next mode will be different depending on the following diving conditions.

•While valid diving............Changes to the surface mode (measuring the resting time on the surface)

•While invalid diving.........Changes to the time and calendar mode or surface mode in continuation from the previous time.

2)While the water sensor is dry, when you press M button for more than 2 secs above a water depth of 4m (15ft), the diving mode will be cancelled.

After cancellation, the mode will change depending on the diving state as in “1”. However if the water sensor gets wet, or is touched by a finger, it is not possible to cancel.

L. Valid and invalid diving used in this watch Valid diving: diving deeper than 1m(4ft) continuously for more than 3mins. An example of 1 dive: (valid diving)

M. The surface mode

[Measurement of reset time on surface]

This is a function which automatically measures the elapsed time (resting time on the surface) after the last valid dive is completed. You can use it for meeting a rest time criteria after completing a dive.

*1: Please look at L. [Valid and invalid diving used in this watch]

In this mode

This is a mode that automatically measures the elapsed time after a valid dive has been completed. (Up to 24 hours)➔“SURF” mode display starts. After 24 hours has elapsed in “SURF” mode, the measurement display automatically stops. This mode will not appear again until the next valid dive has been completed.

When a valid dive is complete, it will start timing automatically. Minimum timing unit is one minute.