Citizen Systems CBM-291 user manual Drawer kick No pin

Condition

LF SW valid.

LF SW invalid.

(20) Enabling/Disabling Panel Switch (ESC c 5 n) Code : [1B]h + [63]h + [35]h + n

* {0 ≤ n ≤ FF} Data is described in Hex code. Selecting the LF switch valid/invalid.

•"n" is valid only in the lowest bit (n0).

•"n" bit means the followings.

N0

0

1

•The initial value of n is "0".

(21) Printing and Feeding the paper by n lines (ESC d n) Code : [1B]h + [64]h + n

* {0 ≤ n ≤ FF} Data is described in Hex code. Prints data inside the buffer and feeds paper by n lines.

•Specified line does not remain.

•The beginning of the line is to be considered as the next printing start position.

•The initial value is not defined.

(22) Generating specified Pulse (ESC p m n1 n2) Code : [1B]h + [70]h + m + n + n2

* {m = connector pin No. (See table below.)} {0 ≤ n1 ≤ FF}

{0 ≤ n2 ≤ FF} Data is described in Hex code. Signals specified by n1, n2 are output to Connector Pin m.

•Bit m (m0) means the followings.

m0	Condition
0	Drawer kick No. 2 pin
1	Drawer kick No. 5 pin

•ON time is considered as n1 x 2ms and OFF time as n2 x 2ms.

•When m is out of the defined range, n1, n2 are discarded, where no signals are output.

•Drive duty of Drawer is shown below:

		ON time
ON time + OFF time	≤ 0.2

(Take OFF time as being 4 times or more longer than ON time.)

(23) Selecting Character Code Table (ESC t n) Code : [1B]h + [74]h + n

*{0 ≤ n ≤ 1} Data is described in Hex code. Selecting Page n on the character code table:

•"n" means the followings.

n (Hex)	Condition
0	IBM Character #2
1	Japanese Character

•The initial value of n is specified by Jumper setting (J1 - J3).

CITIZEN 38