Printer Adjustments
Sensor Adjustments
Adjusting the Transparent sensor
1.Open the printhead and close the sensor arm, then align the positions of the markers on the upper sensor and the bottom
sensor.
Upper sensor marker
Upper sensor
Alignment of markers
Bottom sensor
Transparent sensor marker
2.Select the transparent sensor, and open the sensor arm.
3.Install only the liner media (label backing paper) with the label media removed so that it will pass between the platen roller and the media sensor. (Be careful that media with black marks does not pass the media sensor.) Then close the sensor arm and the printhead.
Upper sensor
Label | Media gap |
Liner media
Bottom sensor
4.If the PAUSE key is pressed and released while the MODE/ REPEAT key is pressed, the PRINT LED goes off, after the CONDITION LED switches from lit to rapid flashing, media feeding starts, and the sensor is automatically adjusted.
5.If automatic adjustment stops normally, the PRINT LED and CONDITION LED return to their original status. If it stops abnormally (adjustment impossible), the CONDITION LED and ERROR LED flash.
6.If the STOP key is pushed, it exits sensor adjustment mode.
35