— 19 —
Initial
Settings
1
Communication condition
DIP switch setting Memory switch ON
setting method
setting
2 Hand shake XON/XOFF DTR/DSR OFF
3 Bit length 7 bits 8 bits OFF
4 Parity check With parity None OFF
5 Parity selection Even parity Odd parity OFF
6ON
7ON
8 INIT Reset Invalid OFF
Selecting baud rate
Switch No.
67
2400 OFF OFF
4800 ON OFF
9600 OFF ON
19200 ON ON
38400 bps can also be selected by a command, etc.
3.6 Setting DIP Switch
The DIP switch is present on the serial interface.
Remove the board fixing screws, take out the interface board, and then set the
DIP switch.
The function of each switch is as shown below.
Baud Rate (bps)
Switch No. Function ON OFF
Baud rate selection See Table below.
DIP switch