English

7. ERROR DISPLAYS

If an error occurs, one of the following displays is displayed.

Take the measures described below to eliminate the problem.

Error Display

Cause

Measure

 

 

 

ERROR 2

A CD is caught inside the CD deck and is

This is a failure of CD deck’s mechanism and

 

not ejected.

consult your store of purchase.

 

 

 

ERROR 3

A CD cannot be played due to scratches,

Replace with a non-scratched,

 

etc.

non-warped-disc.

 

 

 

AMP GRD

The speaker protection circuit is operating.

1. Turn down sound volume. Function can

 

During this operation, if any volume

also be restored by turning the power off

 

operation is performed, the display shows

and on again.

 

“AMP GRD”.

(Speaker volume is reduced automatically

 

 

when the speaker protection circuit

 

 

operates).

 

 

2. If the sound is muted again, consult our

 

 

service department.

 

 

 

If an error display other than the ones described above appears, press the reset button. If the problem persists, turn off the power and consult your store of purchase.

8. SPECIFICATIONS

Radio section

Tuning System: PLL synthesizer tuner

Receiving Frequencies:

FM

: 87.5 to 108 MHz (0.05 MHz steps)

MW

: 531 to 1602 kHz (9 kHz steps)

LW

: 153 to 279 kHz (3 kHz steps)

CD player section

System: Compact disc digital audio system

Frequency Response: 10 Hz to 20 kHz (± 1 dB)

Signal to Noise Ratio: 100 dB (1 kHz) IHF-A

Dynamic Range: 93 dB (1 kHz)

Distortion: 0.03%

Note:

General

Output Power: 4 ✕ 27 W (DIN 45324, +B=14.4V)

Power Supply Voltage:

14.4V DC (10.8 to 15.6 V allowable), negative ground

Power Consumption: Less than 15 A

Speaker Impedance: 4 Ω (4 to 8 Ω allowable)

Auto Antenna Rated Current: 500 mA or less

Weight:

Main unit: 1.2 kg

Dimensions: Main unit :

178 (W) ✕ 50 (H) ✕ 155 (D) mm

• Specifications and design are subject to change without notice for further improvement.

18 DB248R/DB148R/BD149RG