Preset Memory Function

Preset Memory Function can store up to 24 sta-
tions: six stations for each of FM1, FM2, FM3
and AM.
Note:
When the present memory function is used, all the
content of the memory will be erased.
Manual memory function
1) Press the BND button @, and select the
band you want to store in the memory.
2) Press the SRCH Left/Right button #then
select the station you want to store in the
memory.
3) Press and hold the Preset button 0for 2
seconds or longer, then the station will be
stored in the memory.
Auto store function (Automatic Station Store)
1) Press the BND button @, then select the
band you want to store in the memory.
2) Press and hold the AS button 9for 2 sec-
onds or longer, then the station at which the
reception is the strongest will be automatical-
ly stored in the memory.
Note:
When the number of stations stored is less than six,
the previous content of the memory for each direct
button will be retained.

Preset Scanning (Preset Station Scan)

When the PS button 9is pressed, the preset
memory numbers flash and the stations are
tuned in for 7 seconds each in the order in which
they were stored. Press the PS button again to
cancel the preset scanning mode.

Instant Station Recall (ISR)

With this function, a specific radio station can be
recalled from any mode.
ISR memory
1) Press the FNC button 3, then select the
radio mode.
2) Select the radio station which you want to
store in the memory.
3) Press and hold the ISR button 6for 2 sec-
onds or longer.
Recalling ISR
Press the ISR button 6then the display will
show ISR, then the radio station previously
memorized will be selected. Press the ISR but-
ton 6again to disengage the unit from the
Recalling ISR function.

Area Change

Use this function when you are using the car
stereo anywhere outside the U.S.
Switchable frequency spacing
This car stereo is initially set to tune in frequen-
cy intervals of 10 kHz for AM and 200 kHz for
FM, the standard calibrations in the U.S. When
using the unit outside the U.S., use the following
procedure to switch the frequency range.
The table below lists the frequency specifica-
tions for the U.S. and other countries.
Switching the area change
Outside U.S. (New Setting)
While pressing the BND button @, press the
SRCH Left button #, then outside U.S. will be
selected.
Inside U.S. standard (Initial Setting)
While pressing the BND button @, press the
SRCH Right button #, then the U.S. standard
will be selected.
AM
FM
Frequency
spacing
Frequency
range
Frequency
spacing
Frequency
range
Initial Setting
(U.S. standard) New Setting
(outside U.S.)
10 kHz
530 to
1,710 kHz
200 kHz
87.9 to
107.9 MHz
9 kHz
531 to
1,629 kHz
50 kHz
87.5 to
108 MHz
12 DRX5675
English