Setting the Z-enhancer
This unit comes with three types of sound tone effects stored in memory. Select the one you prefer.
*The factory default setting is
Each time you press
•
•
•
•
Loudness Effect
In order to turn on/off the loudness effect, use the LD button 2 for 2 seconds or longer. Every time the LD button 2 is pressed and held for 2 seconds or longer, the loudness effect switches on and off.
*When the loudness effect is on, the display will show “LD”.
Switching the Clock Display
Every time the DISP button 5 is pressed, the display will change between the operation mode and the clock display.
Radio Mode Operations
FM Reception
For enhanced FM performance the ® tuner includes signal actuated stereo control and Multipath noise reduction circuits.
Listening to the Radio
1)Press the FNC button 3 to select the radio mode, then the radio will be on.
2)To select a preset band, press the BND but- ton @, then select one of the preset bands
such as FM1, FM2, FM3, or AM. Every time the BND button @ is pressed, the display will change as:
FM1 ➜ FM2 ➜ FM3 ➜ AM ➜ FM1
3)Press the SRCH Left/Right button #, then the station at which there is a broadcast will be selected (Seek selection).
Mute
Use this function to turn off the sound immedi- ately.
Press the MUTE button %. The sound turns off and “MUTE” appears on the display. Press the MUTE button again to cancel the mute mode.
English
Setting the Clock
1)Press the DISP button 5 to display the clock display.
2)Press and hold the DISP button 5 for 2 sec- onds or longer.
3)Press the SRCH Left button #, then set the current hour.
4)Press the SRCH Right button #, then set the current minute.
5)Press the DISP button 5, then the clock is set.
Notes:
•If you select another operation mode while you are setting the clock, the clock setting operation will be canceled.
•If you remove the vehicle’s battery for a check or repair, the clock will be reset, so you must set it again.
Manual Tuning
1)Press the BND button @, then select FM1, FM2, FM3 or AM.
2)Press and hold the BND button @ for 2 sec- onds or longer, then the display will show “MANU”, which means that a manual selec- tion function is on.
3)Press the SRCH Left/Right button # and select the right station.
Seek Tuning
1)Press the BND button @, then select FM1, FM2, FM3 or AM.
2)If the “MANU” on the display is on, press and hold the BND button @ for 2 seconds or longer. When the “MANU” display is off, the Seek Selection function is on.
3)Press the SRCH Left/Right button #, then when it selects the station in which there is a broadcast, it automatically stops.
DRX5675 11