Clarion DRZ9255 8. IN CASE OF DIFFICULTY, TV Operations, Setting the TV diversity (TV DIVER), P/A, P/A, P/A, ADJ, OFF, ADJ, BAND, TV DIVER, Auto store, Preset scan

English

TV Operations

Auto store

Auto store selects 6 TV stations automatically and stores each one into preset memory.

If there are not 6 stations with good reception, stations previously stored in memory remain and only the strong stations are stored into memory.

1.Press the [BAND] button and select the desired TV band (TV1 or TV2).

2.Press and hold the [P/A] button for 2 seconds or longer. The stations with good reception are stored automatically to the preset channels.

Preset scan

Preset scan allows the user to view each preset position before it automatically advances to the next preset. This function is useful for searching for a desired TV station in memory.

1.Press the [P/A] button.

2.When the desired station is found, press the [P/A] button again to remain tuned to that station.

Note:

•Do not press and hold the [P/A] button for 2 seconds or longer. Doing so will trigger the auto store function and start storing stations into memory.

Setting the TV diversity (TV DIVER)

This function automatically switches to reception by a good-reception antenna during reception of TV broadcasts (when a TV tuner is connected).

*The factory default setting is "ON". Set again to "OFF" when the TV diversity antenna is not in use.

1.Press the [ADJ] button.

2.Press the [] or [] button to select "TV DIVER".

3.Press the [] or [] button to select "ON" or "OFF".

4.Press the [ADJ] button to return to the previous mode.

8. IN CASE OF DIFFICULTY

Problem	Cause	Measure
Power does not turn	Fuse is blown.	Replace with a fuse of the same amperage. If
on.		the fuse blows again, consult your store of
(No sound is pro-		purchase.
duced.)	Incorrect wiring.	Consult your store of purchase.
	Incorrect wiring.	Consult your store of purchase.
No sound output	Power antenna lead is short-	1. Turn the unit off.
when operating the	ed to ground or excessive	2. Remove all wires attached to the power
unit with amplifiers or	current is required for re-	antenna lead. Check each wire for a possible
power antenna attach-	mote controlling on the am-	short to ground using an ohm meter.
ed.	plifiers or power antenna.	3. Turn the unit back on.
		4. Reconnect each amplifier remote wire to the
General		power antenna lead one by one. If the
		amplifiers turn off before all wires are
		required).
		attached, use an external relay to provide
		remote-on voltage (excessive current
Nothing happens	The microprocessor has	Press the reset button for
when buttons are	malfunctioned due to noise,	about 2 seconds with a
pressed.	etc.	thin rod.
Display is not accu-
rate.

			Reset button

	Compact disc cannot	Another compact disc is al-	Eject the compact disc before loading the new
	be loaded.	ready loaded.	one.

	Sound skips or is	Compact disc is dirty.	Clean the compact disc with a soft cloth.
	noisy.

		Compact disc is heavily	Replace with a compact disc with no scratches.
CD		scratched or warped.

	Sound is bad directly	Water droplets may form on	Let dry for about 1 hour with the power on.
	Sound is bad directly	Water droplets may form on	Let dry for about 1 hour with the power on.
	after power is turned	the internal lens when the
	on.	car is parked in a humid
		place.

	The CD is automati-	A CD is loaded upside-	Eject the disc then reload it properly.
	cally ejected.	down inside the CD deck
		and does not play.

English

DRZ9255