Setting Acoustic Features
English
3.Turn the [ROTARY] knob clockwise or counterclockwise to select the value from [MAX], [STD] or [MIN].
•The initial value is [MAX].
•MAX: maximum dynamic range mode of the original source
•STD: recommended mode for standard listening
•MIN: the most compressed dynamic range mode that renders even low sounds easy to hear.
4.Press the [ADJ] button to return to the original mode.
Selecting CTR WIDTH mode will adjust the localization of the centre channel between the centre speaker and the front speaker L/R. Distributing the centre channel sound to the right and left will increase the integrated sound field image, providing you with an natural spatial feeling of sound.
Setting to the value 0 will produce the centre sound with the centre speaker.
Setting to the value 7 will distribute the centre sound to the front speaker L/R as the existing stereo sound does.
• The initial value is [3].
MUSIC Mode Fine Adjustments (PL II CONT)
When MUSIC Mode has been selected on the PL II menu, finer adjustments can be made when desired.
CTR WIDTH is not available when centre speaker is turned off in the section “Turning speakers on or off
1.Press and hold the [ADJ] button for 1 second or longer to enter adjust mode.
2.Press the [a] or [d] button to show the [PL II CONT E] display.
3.Press the [ENT] button to display the adjustment item.
4.Press the [a] or [d] button to select the item.
●PANORAMA (Y or N):Selecting PANORAMA mode will extend the front sound field image to the rear. If surround effect does not seem to be presented sufficiently, select the setting position [Y].
•The initial setting is [N].
●DIMENSION (0 to 6):Selecting DIMENSION mode will shift the sound field image to the front or the rear. If the balance of the sound field image is too much pulled towards the front or rear, the balance front/rear can be corrected.
The adjusting value 3 is the centre position. The range of 3 to 0 shifts the balance front/ rear to the rear. The range of 3 to 6 shifts the balance front/rear to the front.
• The initial value is [3].
10 DVH943
5.Turn the [ROTARY] knob clockwise or counterclockwise to adjust the value.
6.Press the [ADJ] button to return to the original mode.
Setting Auto Volume
1.Press and hold the [ADJ] button for 1 second or longer and enter adjust mode.
2.Press the [a] or [d] button to select the [CALIBRATE E].
3.Press the [ENT] button and [START E] is displayed.
4.Keep driving speed 50km/h and press the [ENT] button.
5.“CALIBRATION” is flash for 2 seconds in display.
6.If calibration is successful display indicate
“SUCCESSFUL” and sound long beep, or if calibration is not successful display indicate “FAILED” and sound 2 times a short beep.
7.If you failed, repeat steps 3 to 6.
Note:
•When installing this device or transferring it into another vehicle, for sake of safety, always have this work done by the store of purchase or your nearest Clarion dealer. Installation requires specialized techniques and experience.
Setting Auto Volume sensitivity
1.Press and hold the [ADJ] button for 1 second or longer and enter adjust mode.
2.Press the [a] or [d] button to select the [A-
VOL SENS]3.Turn the [ROTARY] knob clockwise or counterclockwise to make the adjustment.
The adjustment steps are below 6 steps, Off
➜ Low ➜