6. WIRING TECHNIQUES
Name of Parts
English
*The factory default setting is SLAVE position.
SLAVE STAND
ALONE
1CeNET connectorsConnect to centre unit using CeNET cable.
2Front RCA output connectorsConnect to external power amplifier using RCA pin cable.
3Rear RCA output connectorsConnect to external power amplifier using RCA pin cable.
4
5Centre speaker RCA output connectors Connect to external power amplifier using RCA pin cable.
6Digital input connectorConnect to DVD/CD changer using optical digital cable (sold separately or included).
*Connect to black connector side
7Cable clip holeInsert cable clip to hold optical digital cable in place.
8RESET switchPress to reset circuitry if no sound is produced.
Note:
•Be sure the CeNET cable is connected when pressing the [RESET] switch.
Speed pulse cord
Connect to speed pulse signal cord of the vehicle. If you already own DXZ748RMP and use it with Auto Volume, disconnect the speed pulse cord and replace with the speed pulse cord provided with this unit, then perform calibration.
Use When Connecting Optional Control Unit (DVC923)9•Set to STAND ALONE when connecting a control unit.
•Leave at SLAVE position when no control unit is connected.
0Analog input connectors (RCA) Connect to centre unit’s RCA 2ch output.Note:•The following are enabled only when a control unit is connected.
!Control unit 8P mini DIN plug Connect to control unit.@Control unit power connector Connect control unit’s power cable here.*Leave tape in place when not in use.
DVH943 11