Clarion DXZ735MP Operations Common to Each Mode Dimmer control, Adjusting the display contrast

Operations Common to Each Mode

Dimmer control

You can setting the dimmer control on or off.

∗The factory default setting is “ON”.

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button to select “DIMMER”.

3.Turn the [ROTARY] knob clockwise to “ON” or counterclockwise to “OFF”.

4.Press the [T] button to return to the previous mode.

Adjusting the display contrast

You can adjust the display contrast to match the angle of installation of the unit.

∗The factory default setting is “6”. (Adjustment level:1to 11)

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button to select “CONTRAST”.

3.Turn the [ROTARY] knob clockwise or coun- terclockwise to adjust the contrast.

4.Press the [T] button to return to the previous mode.

2.Press the [a] or [d] button to select “SUB-W LPF”.

3.Turn the [ROTARY] knob clockwise or coun- terclockwise to select the setting. Each time you turn the [ROTARY] knob, the setting changes in the following order:

REAR ➜ LPF 50Hz ➜ LPF 80Hz ➜ LPF 120Hz

4.Press the [T] button to return to the previous mode.

Selecting AUX IN sensitivity

Make the following settings to select the sensi- tivity when sounds from external devices con- nected to this unit are difficult to hear even after adjusting the volume.

∗The factory default setting is “MID”.

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button to select “AUX SENS”.

3.Turn the [ROTARY] knob clockwise or coun- terclockwise as needed and select from “HIGH”, “MID” or “LOW”.

4.Press the [T] button to return to the previous mode.

English

Anti-theft indicator

The red Anti-theft indicator is a function for pre- venting theft. When the DCP is removed from the unit, this indicator blinks.

∗The factory default setting is “OFF”.

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button and select “BLINK LED”.

3.Turn the [ROTARY] knob clockwise to set this function “ON” or turn it counterclockwise to switch this function “OFF”.

4.Press the [T] button to return to the previous mode.

Setting LOW PASS FILTER

∗The factory default setting is “LPF 120Hz”.

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

Setting the clock

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button to select “CLOCK”.

3.Press the [ ] button.

4.Press the [a] or [d] button to select the hour or the minute.

5.Turn the [ROTARY] knob clockwise or coun- terclockwise to set the correct time.

∗ The clock is displayed in 12-hour format.

6.Press the [ ] button to store the time into memory.

7.Press the [T] button to return to the previous mode.

Note:

•You cannot set the clock when it is displayed with only the ignition on. If you drain or remove the car’s battery or take out this unit, the clock is re- set. While setting the clock, if another button or operation is selected, the clock set mode is can- celed.

DXZ735MP 21