6. INSTALLATION
CAUTION
•Disconnect the battery negative cable before connecting the wiring.•If you are making holes in the vehicle body in order to install the unit, first confirm the position of pipes, tanks and electrical wiring to avoid contact and interference.
•When installing the wiring for connection cords on a vehicle equipped with airbags, do not install the wiring where it may affect the airbag system.
•Do not cover the ventilation holes and■ Installation Using Screws | ■ Installation Using Velcro Tape | ||||
1. When using the installation holes at the | 1. | Apply Velcro tape to the bottom surface of | |||
sides of the unit, use M4 ✕ 8 screws. Using |
| the unit. |
|
|
|
screws other than the specified screws may |
|
|
|
|
|
cause a malfunction. | 2. | Attach the unit to the floor carpet beneath | |||
|
| the seat. |
|
|
|
2. If you are going to drill holes in the |
|
|
|
|
|
dashboard, make sure beforehand that |
|
|
|
|
|
there are no harnesses behind the |
|
|
|
|
|
dashboard at that position or nearby. |
| MODEL | TT |
| |
|
|
| |||
|
|
| X754 | ||
|
| CeNET TV | Tuner | ||
|
|
| 12V |
| |
|
| VHF |
| GROUND | |
|
| UHF 4 |
| ||
|
| 71.25MHz- | .25MHz | ||
|
|
| 855.25MHz | ||
|
|
|
|
| 8mmMAX |
Chassis
English
Max. 8 mm
7. CAUTIONS ON WIRING
Pay particular attention to the following points when laying out the cords.•Keep the unit’s cables as far away as possible from the vehicle’s wiring bundles.
•Keep the unit’s RCA pin cord and the power cord separated as far as possible.
CAUTION
•When you have finished connecting the cords, secure them with clamps and insulating tape for protection.
•Make sure that the connection cables will not get caught on burrs and edges of the metal parts under the seat. It could damage the cables and cause noise from the unit.
•To assist safe driving, connect the parking brake connection terminal to the lead wire on the lamp side of the parking brake lamp switch.
TTX754 7