Clarke 1600 HOW to Prepare the Machine for Operation, How To Install The Sandpaper, Initial Cut

Figure 1

Figure 2

Figure 3

HOW TO PREPARE THE MACHINE FOR OPERATION

WARNING: Always remove the electrical plug from the electrical outlet before installing or changing the sandpaper.

How To Install The Sandpaper

To install the sandpaper, follow this procedure:

1.Put the handle in the vertical position.

2.Lock the handle. To lock the handle, push the locking lever down. See figure 1.

3.Tilt the machine backward until the handle is on the floor.

4.Put one foot on each side of the machine.

5.Using a 7/8 wrench, remove the nut and the washer that hold the paper holder. See figure 2.

6.Put the sandpaper on the sanding pad.

7.Put the paper holder in position. See figure 3.

8.Install the washer and the nut that hold the paper holder.

Sanding Cuts and Sandpaper

(See chart on page 14)

Initial Cut

The purpose of the initial cut is to remove old finish and gross imperfections on the floor surface. A coarse abrasive should be used.

If glazing, loading, or burning takes place immediately into an initial cut, select a coarser abrasive. If this should occur during an initial cut, the abrasive has dulled and must be replaced.

Final Cuts

The purpose of a finishing cut is to remove the scratches produced during the initial cut. Use a fine (60-80 grit) grain abrasive.

If the surface remains rough after a finishing cut, it may be necessary to use an even finer grain of abrasive

(80-100 grit). Care should be taken in selecting the grit size of the abrasive. A very fine grain will close the pores on a wood floor making admission of a stain difficult.

Page -12 - Clarke® American Sanders Operator's Manual - Sander 1600 120V