How To Prepare the Machine For Operation
4.Disconnect the battery pack connector from the control housing connector. See figure 14A.
5.Connect the DC connector on the charger to the battery pack connector. See figure 14B.
6.Connect the charger to a properly grounded single phase
For more information on the use of the charger, read the instructions supplied with the charger.
How To Adjust Brush Cleaning Path from 24" to 26"
1.Insure brush head is in up position.
2.Turn the key switch "OFF" and remove the key.
3.Open front cover.
4.Raise plunger pin and rotate brush head. See figure 15.
5.Insure plunger pin is engaged in brush plate.
6.Close front cover.
How To Install The Brushes Or Pad Drivers
To install the brushes or pad drivers on the machine, follow this procedure:
1.Turn the key switch "ON".
2.Raise the brush head by pressing and holding the brush switch until brush head is in its full up position.
3.Turn the key switch "OFF" and remove the key.
4.Go to the front of the machine and unlatch front cover, swing coveropen.
5.Unlatchrightandleftbrush housings andremovethem. See figure 16.
6.Put a brush or pad driver under the brush motor plate. See figure 17.
7.("L" Model) Align the lugs on the motor gimbal with the slots in the brush gimbal.
("S" Model) Align the lugs on the motor with the slots on the brush gimbal.
8.("L" Model) Pull the brush up until the gimbal locks.
("S" Model) Pull the brush up and rotate counter direction to scrub rotation, until lugs lock.
9.Repeat steps 6, 7, and 8 to install the second brush or pad driver.
10. Reinstall right and left brush housings and latch front cover.
DANGER: Operating a machine that is not completely or fully assembled could result in injury or property damage. Do not operate this machine unless it is completely assembled. Inspect the machine carefully before operation.
Figure 14A
Figure 14B
Figure 15
Figure 16
Figure 17
Clarke® Operator's Manual - Encore S30/L30 | Page |