How To Operate The Machine
When filling machine from the rear, position clear drain hose against bracket and insert hose as shown in figure 20B Solution level can be viewed from the back of the machine.
WARNING: Water solutions or cleaning materials used with this type of machine can leave wet areas on the floor surface. These areas can cause a dangerous condition for the operator or other persons. Always put CAUTION signs near the area you are cleaning.
WARNING: Machines can ignite flammable materials and vapors. Do not use with or near flammables such as gasoline, grain dust, solvents and thinners. Only use a cleaning concentration recommended by the chemical manufacturer.
WARNING: Clarke recommends a maximum water temperature of 120oF (49oC).
Operating The Machine
NOTE: Put the machine in the lowest traverse speed setting. Use the machine in an area that has no furniture or objects until you can do the following:
1.Move the machine in a straight direction, forward and backward.
2.Stop the machine safely.
3.Turnthemachinebothleftandrightandreturntoa straight direction.
To move the machine, follow this procedure:
1.Release the parking brake (if equipped with machine).
2.Turn the key switch to the "ON" position
3.Raise the brush to the highest setting.
4.Raise the squeegee.
5.When either the left or right forward/reverse switches (figure 21, item A) are pushed in, the machine will go forward.
6.Control the speed of traverse by using the traverse speed control knob (figure 21, Item C).
7.To stop, release the forward/reverse switch.
8.To reverse the machine, push in the white reverse switch (figure 21 item B) and either the right or left forward/ reverse switch (figure 21 item A) at the same time.
9.To stop, release the forward/reverse switch.
10.To turn the machine, push the rear of the machine to the side.
11.When you stop the machine, turn the key switch "OFF", remove the key and set the parking brake (if equipped).
B
A
Figure 20B
C
A
Figure 21
Clarke® Operator's Manual - Encore S30/L30 | Page |