Maintenance
Maintenance For The Squeegee
To remove the squeegee, follow this procedure:
1.Remove the squeegee assembly by loosening the two knobs that attach the squeegee to the machine. Pull the squeegee assembly off. See figure 31.
2.Inspect the squeegee blade.
3.If the blade is worn, turn the blade so that a new edge is in the wiping position.
4.Reinstall squeegee assembly on the machine.
How To Adjust The Squeegee
The following adjustments are set at the factory, however they may require slight adjustment.
Adjusting Squeegee Tilt:
The tilt of the squeegee causes the rear blade to raise up in the center or on the ends, depending on which direction the tilt is changed. For tilt adjustment, refer to figure 32. Loosen left and right screw "X". In order to bring the blades down in the center, tip "Y" down. To bring both ends down, tip "Y" up. Make very small adjustments and try it until a uniform flare is achieved.
Adjusting Squeegee Blades:
When properly installed the front blade should be approximately 0.06" (1.5mm) above the rear blade. See figure 33.
WARNING: Maintenance and repairs must be done by authorized personnel only .
WARNING: Electrical repairs must be done by authorized personnel only.
Figure 31
Figure 32
REAR BLADE | 0.06 (1.5 mm) |
|
|
|
| ||
|
| ||
|
|
|
|
| Figure 33 |
| |
Page | Clarke® Operator's Manual |