Maintenance cont.
Consult your Clarke Authorized Service Person to do the service procedures.
Use only genuine Clarke parts.
How to Center or Offset the Brush Head | 1 |
| |
The brush head on the Encore 30 should be adjusted | 2 | ||
| |||
|
|
as far to the left side of the machine as possible.
3
Recommended tools: 3/8" drive rachet, 3" extension |
|
and 9/16" socket. |
|
CAUTION: Before offsetting the brush head, | 4 |
be sure that the recovery tank is |
|
empty of solution. Follow the in- |
|
structions on page 20 on how to |
|
drain the recovery tank. |
|
1.Turn the key switch "ON".
2.Raise the brush head by pressing and holding the brush switch until the brush head is in its full up
position. | Figure 34 |
3.Turn the key switch "OFF" and remove the key.
4.Tip up the recovery tank until it locks in the full open position.
5.Go to the front of the machine and unlatch the front cover and swing cover open.
6.Locate the four mounting studs on the brush head bracket. See figure 34. The top two mounting nuts can be accessed through the top of the solution tank. The lower two can be accessed through the front. Loosen the four mounting nuts 2 to 3 turns counterclockwise. NOTE: Donotremovemounting nuts.
7.The brush head assembly can slide to the right side by one inch or placed back into the center. Slide the brush head assembly all the way to the ends of the slots for the desired position. This insures that the head operates straight up and down.
8.After repositioning the brush head, tighten nuts securely to approximately 236
9.Close the front cover.
10.Close the recovery tank.
Clarke® Operator's Manual - Encore S30/L30 | Page |